Survey finding
Wimpey No-Fines house: survey, mortgage and what to do
Wimpey No-Fines house mortgage problems and Wimpey No-Fines house survey questions are common despite the construction NOT being designated defective. This page covers what to look for and how lenders treat it.
Last updated: 6 May 2026. Editorially reviewed: 20 May 2026.
Finding
Wimpey No-Fines concrete house
What this usually means
Wimpey No-Fines is a poured concrete construction method used by George Wimpey & Co between roughly 1946 and the 1970s. The walls are mass concrete with no fine aggregate (so no sand), the cement binds gravel-sized aggregate directly. About 300,000 Wimpey No-Fines houses were built in the UK. Unlike Airey or Cornish Unit, Wimpey No-Fines was NOT designated defective under the Housing Defects Act 1984, but is non-standard construction with documented defects (vertical wall cracking, render spalling, thermal performance issues).
Why it matters
Wimpey No-Fines is mortgageable but not by every lender. Mainstream UK lenders' panels split, some accept readily with a satisfactory survey, others restrict to specialist panels. The construction is fundamentally sound; the cosmetic and thermal issues are the headline buyer concerns.
Ask your surveyor
- Check:Are there visible vertical cracks in the no-fines concrete walls?
- Check:Is the render in good condition or showing horizontal cracking above window drips?
Ask the seller
- Check:Has any concrete or render repair been carried out?
- Check:Has external wall insulation been added?
Next steps
- •Confirm with your broker which lender will accept this construction type before paying for any further surveys.
- •Order a structural engineer's report if no recent one exists in the property's records.
Browse all findings
- Spray foam insulation
- Evidence of movement
- Damp
- Japanese knotweed
- Damp proof course issues
- Underpinning
- Cracks
- Roof issues
- Timber decay
- Electrical issues
- Non-standard construction
- Asbestos containing materials
- Roof covering needs repair
- Single skin wall construction
- Timber decay / wet rot
- Settlement cracks
- RAAC concrete
- Wall tie failure
- Party wall matters
- Drainage issues
- Subsidence monitoring
- Full electrical rewire needed
- Flat roof condition
- Cladding issues
- EWS1 form required
- Lintel failure
- Structural crack BRE category 3
- Structural crack BRE category 4-5
- Chimney stack movement
- Chimney flashing failure
- Parapet wall movement
- Bay window cracking
- Flat roof ponding
- Cold roof inadequate ventilation
- Warm roof insulation issues
- Prefab concrete construction
- Large panel system (LPS) construction
- Rising damp
- Penetrating damp
- Condensation vs damp distinction
- Dry rot (Serpula lacrymans)
- Woodworm
- Timber floor springiness
- Cellar / basement damp
- Outdated electrics (60-amp fuse board)
- Aluminium wiring
- Partial rewire needed
- Gas boiler condition
- Back boiler
- Unvented hot water cylinder issues
- Lead pipes (pre-1970)
- Lead paint
- Asbestos in Artex ceilings
- Asbestos floor tiles
- Asbestos cement roof
- Asbestos insulated board (AIB)
- Asbestos soffit boards
- Pointing / repointing needed
- Render cracking
- Pebbledash delamination
- UPVC window seal failure
- Sash window condition
- Flat roof membrane condition
- Zinc roof
- Felt roof condition
- Corrugated asbestos roof
- Cavity wall insulation issues
- External wall insulation issues
- No building regulations certificate
- No planning permission for extension
- Certificate of lawfulness needed
- Indemnity insurance required
- Neighbour dispute on file
- EPC F or G rating
- Oil heating property
- Off-gas-grid property
- Solar panel lease vs owned
- Ground source heat pump property
- Air source heat pump property
- Chimney breast removed without support
- Floor joist decay
- Wall bowing
- Mould and condensation
- Septic tank property
- Thatched roof condition
- Listed building restrictions
- Conservation area restrictions
- Restrictive covenants on title
- Coal mining area
- Coastal erosion risk
- Flood risk zone 3
- Radon affected area
- Contaminated land history
- Trees near building
- Party wall agreement outstanding
- EICR required
- Knotweed treatment history
- Single glazing condition
- RCD protection missing
- Damp-proofing guarantee transferability
- PRC (precast reinforced concrete) house
- Airey house
- BISF (British Iron and Steel Federation) house
- Timber frame construction
- Steel frame house
- Wet rot
- Heave (ground movement)
- Chimney condition and stability
- Short lease (under 80 years)
- Fire safety: flat and leasehold issues
- Blocked or condemned flue
- Spalling brickwork
- Diagonal cracks in walls
- Retaining wall condition
- Tanking failure in basement
- Missing or slipped ridge tiles
- Lead flashing condition
- Gutters and downpipes
- Double glazing condensation (failed units)
- Skylight or roof light condition
- Dormer condition and weathering
- Torn or missing sarking felt
- Chancel repair liability
- Easement or right of way
- Boundary dispute or unclear boundary
- Adverse possession risk
- Flying freehold
- Ground rent escalation clause
- High or variable service charge
- Extension without planning consent
- Loft conversion: no building regs
- Single-phase electrical supply only
- Shared or private sewer
- Blocked or collapsed drains
- Cesspit or septic tank
- Solid fuel heating
- No mains gas supply
- Low water pressure
- Private water supply
- Wimpey No-Fines concrete house
- Reema construction
- Unity or Boot construction
- Laing Easiform
- Cornish Unit house
- Cross-wall construction
- In-situ concrete construction
- Oak frame construction
- Radon: mitigation required
- Missing or inadequate fire alarms
- Single staircase: means of escape
- No earthing or bonding
Tool shortcut
Check the property before you offer
Flood, subsidence, EPC, crime, schools, transport, broadband, tenure, age, listed status and price checks where data is available.
Run a free previewCross-check this finding with EPC, building age, and address-specific risk data.
What you need to know
Severity
Significant. Specialist follow-up usually warranted before exchange.
Typical cost to fix
Vertical crack repair (specialist concrete repair): £600–£2,500. Render replacement: £4,000–£10,000+. External wall insulation upgrade (recommended for thermal): £8,000–£15,000+. Specialist structural engineer's report £400–£900.
Mortgage impact
Mortgageable on a meaningful share of mainstream lender panels with a satisfactory structural engineer's report. Some lenders restrict LTV to 75–85%. A small number decline outright. Always confirm with broker before paying for the survey.
Insurance impact
Standard buildings insurance is widely available on Wimpey No-Fines. Premiums vary but the property is not in the specialist non-standard-construction insurance market.
When to pull out
Pull out only if the structural engineer's report flags active concrete deterioration. The seller refuses to engage, and your lender refuses.
When to renegotiate, and by how much
If standard construction issues (cracking, render) are flagged, negotiate on engineer's quoted remediation plus 15%. If the property is sound, treat as standard.
Thinking of pulling out or renegotiating? What to do after a bad survey
Run the check on this address
The Survey Decoder explains the wording. The full report adds address-specific flood, subsidence, EPC, crime, listed status, building age and price comparison data, so a single finding isn't judged in isolation.
Run the check
Check the property before you offer
Flood, subsidence, EPC, crime, schools, transport, broadband, tenure, age, listed status and price checks where data is available.
Run a free previewRead next
Non-standard construction , often sits near wimpey no-fines concrete house on a survey and is the next thing to check.
Editorial review
Editorial owner: BiteRight Ltd, operator of MyPropertyScan. We review buyer guides against UK public property datasets, RICS survey wording, lender requirements, and common buyer questions.
Pages are updated when source coverage, property-risk guidance, survey cost assumptions, or product checks materially change. Methodology and dataset limitations are explained on the MyPropertyScan methodology page.
Sources used
We use UK public and specialist sources where they are available. Public datasets can be incomplete, delayed, or missing for some addresses. Treat them as a starting point, not as a replacement for professional advice.
Source standard: preference goes to official government datasets, statutory bodies, professional standards, and primary dataset publishers. We cite the source family on the page and explain coverage limits rather than filling gaps with unsupported estimates.